[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Re[2]: TS2000i Hung Up



PureBytes Links

Trading Reference Links

Many thanks David.

Bob

----- Original Message -----
From: "David Rosenthal" <davidrnews@xxxxxxxxxxxxx>
To: "Bob Heisler" <BHEISLER@xxxxxxxxx>; "ztrader" <ztrader@xxxxxxxxx>;
"Larry Viles" <larryv@xxxxxxxxxxxx>; "omega-list" <omega-list@xxxxxxxxxx>
Sent: Wednesday, September 05, 2001 10:38 PM
Subject: RE: Re[2]: TS2000i Hung Up


> OK.  The attached file accomplishes the same thing as the file that Omega
support
> gave to Bob, but it is safer because it does *nothing else* but change the
one
> registry item that controls the behavior of opening workspaces at startup.
Perhaps
> the other entries in the original file are harmless, but they sure don't
look it!
> It seems to me that Omega support was just a little bit lazy when they
made this
> file for Bob... imagine that...
>
> I've tested this here and it works fine, but use at your own risk, etc.
etc.
>
>   David
>
> > -----Original Message-----
> > From: Bob Heisler [mailto:BHEISLER@xxxxxxxxx]
> > Sent: Wednesday, September 05, 2001 8:06 PM
> > To: David Rosenthal; ztrader; Larry Viles; omega-list
> > Subject: Re: Re[2]: TS2000i Hung Up
> >
> >
> > That file was sent to me by Omega and at the time I was using PC Quote.
> > It's not something I created or have the ability to create.  All I know
is
> > that on the few occasions that I needed to use it it worked fine.  If
you
> > can modify it as you indicated then it might be an even better tool for
us
> > to have access to.
> >
> > Bob
> >
> > ----- Original Message -----
> > From: "David Rosenthal" <davidrnews@xxxxxxxxxxxxx>
> > To: "Bob Heisler" <BHEISLER@xxxxxxxxx>; "ztrader" <ztrader@xxxxxxxxx>;
> > "Larry Viles" <larryv@xxxxxxxxxxxx>; "omega-list"
<omega-list@xxxxxxxxxx>
> > Sent: Wednesday, September 05, 2001 9:27 PM
> > Subject: RE: Re[2]: TS2000i Hung Up
> >
> >
> > > Bob,
> > >
> > > I took a look at the registry entries in this file, and it looks quite
> > dangerous for
> > > general release, as it sets 'TypeofDataFeed" to Signal, and
InitialFileDir
> > to a
> > > directory on C:.  This undoubtedly worked on your system but might
cause
> > havoc on
> > > someone else's.  To stop workspaces from loading at startup, would it
be
> > sufficient
> > > just to set the "OpenWorkspaceFlag" registry item??
> > >
> > > > -----Original Message-----
> > > > From: Bob Heisler [mailto:BHEISLER@xxxxxxxxx]
> > > > Sent: Wednesday, September 05, 2001 3:43 PM
> > > > To: ztrader; Larry Viles; omega-list
> > > > Subject: Re: Re[2]: TS2000i Hung Up
> > > >
> > > >
> > > > Hi Z,
> > > >
> > > > Unfortunately corrupted workspaces are not uncommon.  If you know
which
> > file
> > > > is corrupted you can do as Mike suggested.  But if you don't know
you
> > can
> > > > run the attached file (with TS closed) and it will change the
settings
> > and
> > > > prevent any workspaces from being loaded upon startup.  Then you can
> > > > troubleshoot to find out which one is bad by loading them one at a
time.
> > > >
> > > > Once found just delete it and recreate it.  Then load all your
normal
> > > > workspaces and re-select the
> > > > option "Open charts from previous Session" under the Desktop Options
> > menu.
> > > > It will then load them at startup again.
> > > >
> > > > Can you tell I've "been there done this" before?  hehe.  It's a very
> > handy
> > > > file to have at your disposal.
> > > >
> > > > Bob Heisler
> > > > www.rjhtrading.com
> > > >
> > > >
> > > > ----- Original Message -----
> > > > From: "ztrader" <ztrader@xxxxxxxxx>
> > > > To: "Larry Viles" <larryv@xxxxxxxxxxxx>; "omega-list"
> > > > <omega-list@xxxxxxxxxx>
> > > > Sent: Wednesday, September 05, 2001 5:21 PM
> > > > Subject: Re[2]: TS2000i Hung Up
> > > >
> > > >
> > > > > On Wednesday, September 05, 2001, 1:01:11 PM, Larry Viles wrote:
> > > > >
> > > > > LV> From: "Bob Heisler" <BHEISLER@xxxxxxxxx>
> > > > >
> > > > > >> Here's a file that will prevent TS from opening any workspaces
at
> > > > startup.
> > > > >
> > > > > What file is that? Sounds useful. Also, do you have a way to tell
> > > > > which indicator is missing?
> > > > >
> > > > > ztrader
> > > > >
> > > > >
> > > >
> > >
> >
>