|
PureBytes Links
Trading Reference Links
|
I cannot see why you use the old IncludeSystem feature in TS2000i.
Better use User functions that does the same than the included system(s) if
you wish to use them again in different systems.
Rgds,
PO
www.sirtrade.com
-----Message d'origine-----
De : Clyde Lee <clydelee@xxxxxxx>
À : Omega List <omega-list@xxxxxxxxxx>
Date : Wednesday, March 29, 2000 01:34
Objet : Recalculation after Changes in Code
>Maybe you have not observed this or it is not a real problem to you
>but to me it is something that is VERY, VERY, VERY EXPENSIVE OF
>TIME in my work.
>
>The following was sent to Omega to explain the situation where if
>I have a routine buried 3 levels deep in a system and recompile that
>one routine then TS2000 recalculates ALL active symbols with a
>system that involves that routine THREE times -- yes it recalculates
>everything 3 times.
>
>My work typically involves about 20 to 40 symbols with a single system
>applied. As noted, just one recalculation takes 3 to 5 minutes -- three
>of them up to 15 minutes.
>
>OMEGA says that is the way it is and did not indicate that it might be
>any different.
>
>What I have found:
>
>Just do anything at all to the HIGHEST level (system normally) so that
>it will eventually have to be recompiled.
>
>Change and re-verify the lower level routine(s) and then re-verify the
>highest
>level routine -- DO THIS AND IT ONLY RECALCULATES ONCE.
>
>Clyde
>
>
>> Subject: Major FU in Recompilation in TS2000
>>
>> I have the following situation:
>> Level1: SYSTEM: MASTER nothing more than IncludeSystem:
>> "C_Lee........
>> Level2: SYSTEM: C_LEE_............ system referred above and
>includel
>> below function
>> Level3: Function: Fib_Number_con.........
>>
>> The level 1 system is applied to 20 commodities in one Workspace.
>> Actually it is applied to 40 commodities in two Workspaces but the
>second
>> Workspace is not loaded.
>> If I make a change to the Level3 Function TS2000i recalculates ALL
>> commodities because of the change in Level3 and then recalculates
>ALL
>> commodities because of the change in Level3 and then recalculates
>ALL
>> commodities because of the change in Level3.
>> Now this really does happen and it really should only recalculate
>once.
>> Can't something be done about this.
>> Each recalculation takes 3 to 5 minutes. It is a pain to have to wait
>15
>> minutes for something that should take at most 5.
>> Clyde Lee
>> - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
>
>
>
|