PureBytes Links
Trading Reference Links
|
Sounds very strange....but there is an easy workaround.....
just copy the code via Ctrl-C (after highlighting it).....
then create a new Function or indicator....with the DLL references already
removed..
> -----Original Message-----
> From: Larry Wright [mailto:lwright@xxxxxxxxxx]
> Sent: Friday, November 12, 1999 4:34 PM
> To: Omega List
> Subject: Strange EL bug in SP3?
>
>
> I have a TS4 indicator that uses the hashnums DLL, but don't have hashnums
> for TS2k. I copied the indicator to TS2k, verified it, and sure enough TS
> says it can't find the DLL. So far, so good.
>
> I first tried commenting out the DLL code, but I still got the error
> message. I then removed ALL the references to the DLL, including *all* the
> variables used to address the DLL. I verified that these were NOT in the
> code by using the EL search function for all the names, including all the
> DLL references - 'Find' agreed: no references of any kind could be found
> in the code. However, I *still* get the error message "can't find the
> DLL", and it will still not run.
>
> This may be new to SP3. I copied a similar indicator with SP2 and got it
> to work OK by commenting out the DLL code. There seemed to be some comment
> bracket problems in SP2 (still there in SP3) - EL did not think it was
> removed if I had any nested comment brackets, but by commenting only with
> single non-nested brackets, I did get the code to run in SP2. This
> technique did not work in SP3.
>
> Anyone notice anything like this? Any thoughts as to the error with NO DLL
> references whatever in the code?
>
> Larry
>
|