|
PureBytes Links
Trading Reference Links
|
>From the Omega Research Knowledge Base:
7.If the Security Block is on an LPT port other than LPT1, the SYSTEM.INI
file, [386Enh] section must contain the following line:
1.. Click the Start | Run menu sequence.
2.. At the Open: edit box type SYSEDIT and click OK. This will bring up
the System Configuration Editor.
3.. Select the Window | SYSTEM.INI menu sequence.
4.. Scroll down to the line that reads [386Enh]. Check until the next
blank line for a line that reads SSI_LPT=n (where n=1,2,3) depending what
port the block is on. There should NOT be a semicolon (;) in front of the
line. If the line does not exist, add it immediately under the [386Enh]
line.
5.. Click the File | Save menu sequence.
6.. Click File | Exit.
----- Original Message -----
From: "John F. Berentson" <jberentson@xxxxxxxxxx>
To: "Kent Rollins" <kentr@xxxxxxxxxxxxxx>; "OmegaList"
<omega-list@xxxxxxxxxx>
Sent: Monday, September 04, 2000 22:54
Subject: RE: Pointing TS4 to LPT2?
> Tradestation 4 must use LPT1. I ran into this problem when I had two
devices
> that both required LTP1 and could not share. I had to push one off the end
> of the pier.
>
> -----Original Message-----
> From: Kent Rollins [mailto:kentr@xxxxxxxxxxxxxx]
> Sent: Monday, September 04, 2000 2:20 PM
> To: OmegaList
> Subject: Re: Pointing TS4 to LPT2?
>
>
> I don't think you need to change any settings anywhere. The security
> library that Omega uses should search all the ports in your system to find
> the one with the key it is looking for.
>
> Kent
>
>
> -----Original Message-----
> From: ChasWaring <cwwaring@xxxxxxxxxxxxxx>
> To: omega-list@xxxxxxxxxx <omega-list@xxxxxxxxxx>
> Date: Monday, September 04, 2000 7:03 AM
> Subject: Pointing TS4 to LPT2?
>
>
> I haveTS4 running on win2000 and would like to point TS4 to the LPT2
instead
> of the LPT1 port.
>
> Could someone tell what does that in TS4?
>
> TIA,
> Charlie
>
>
|