Re: [amibroker] Re: Scaling out example code does not work

[Graham <kavemanperth@xxxxxxxxx>]

The values calculated for scaling conditions are probably based on the
initial & subsequent trade prices with a zero bar trade delay.
If your delay is one bar then you must change the code to accommodate
the altered trade prices to one bar after the signal.


-- 
Cheers
Graham Kav
AFL Writing Service
http://www.aflwriting.com


2009/1/6 ezbentley <ezbentley@xxxxxxxxx>:
> Hi Howard,
>
> Thanks for the reply. I have recently learned from Tomasz that trade delays must be all set to
> ZERO in order for the scaling code to work. While it does not make intuitive sense why trade
> delays should affect scaling, it works now.
>
>

------------------------------------

**** IMPORTANT ****
This group is for the discussion between users only.
This is *NOT* technical support channel.

*********************
TO GET TECHNICAL SUPPORT from AmiBroker please send an e-mail directly to 
SUPPORT {at} amibroker.com
*********************

For NEW RELEASE ANNOUNCEMENTS and other news always check DEVLOG:
http://www.amibroker.com/devlog/

For other support material please check also:
http://www.amibroker.com/support.html

*********************************
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/amibroker/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/amibroker/join
    (Yahoo! ID required)

<*> To change settings via email:
    mailto:amibroker-digest@xxxxxxxxxxxxxxx 
    mailto:amibroker-fullfeatured@xxxxxxxxxxxxxxx

<*> To unsubscribe from this group, send an email to:
    amibroker-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/