PureBytes Links
Trading Reference Links
|
Dear Sir,
The problem is not in HyperServer, but your XPO file use a different
SubServer ID.
Generally HyperServer have in use ID 75,then GlobalServer for import
successfully your XPO requires the internal ID as 75, but your file have in
use adifferent ID. You can change the ID by HyperTools
Robert Giordano
HyperTrader Tech. LLC
----- Original Message -----
From: "Kirk Walker" <traderkirk7@xxxxxxxxx>
To: "Omega" <omega-list@xxxxxxxxxx>
Sent: Sunday, July 04, 2004 6:18 PM
Subject: Hyperserver subserver problem
> Hi list,
>
> I had to reinstall TS (long story, but basically it
> involved fixing the blank strategy performance report)
> and now I am having trouble getting my data to work
> again. I did the reinstall on top of the old
> installation in an effort to keep all of my old
> settings intact (perhaps this is the cause of my
> problem).
>
> I am using Hyperserver Lite for MetaTrader. When I
> went to import some data from an XPO file into the GS
> I get the message "Subserver DLL not found". So I
> tried uninstalling Hyperserver, and I ran the GS setup
> wizard and changed to the DBC subserver (just to
> remove the Hyperserver reference and start over).
> Then I reinstalled Hyperserver and re-ran the GS setup
> wizard to set the Hyperserver subserver back up again.
> That part worked fine but I still get the same error
> message when trying to import new data.
>
> Anyone else had this problem and know the solution?
>
> Thanks
>
>
>
>
>
>
|