Re: No width in 2000i

["Benjamin Blanco" <ezlang@xxxxxxxxxxxxxxxxxx>]

Some changes made in the PowerEditor while the technique is applied to a
chart will not be seen until the technique is reapplied.  For example, if
you change the default value of an input in the PowerEditor and verify while
the technique is applied to the chart then you will not see the changes.

Solution: Remove and reapply the technique.


Best regards,

Benjamin Blanco,
EasyLanguage Specialist
( former TradeStation Technologies, Inc. employee of six years )
http://www.benjaminblanco.com/

EasyLanguage is a registered trademarks of TradeStation Technologies, Inc.

----- Original Message -----
From: "Blitz" <rlofgre1@xxxxxxxxxx>
To: <omega-list@xxxxxxxxxx>
Sent: Thursday, April 03, 2003 3:40 PM
Subject: No width in 2000i


I have a display problem in 2000i. Although it runs fine, it won't allow any
"width" settings to display on bars or indicators.
It shows in the little "Preview" window that the changes have been effected,
but there's no difference in charting.

Anybody know how to fix?
                                Thanks