Re: Code Conversion

["sunfiles" <sunfiles@xxxxxxx>]

Can you post the code for the pivot line?

Thanks,
Brian Oliver
sunfiles@xxxxxxx
Newport Coast, CA


----- Original Message -----
From: "Don Ewers" <dbewers@xxxxxxxxxxxxx>
To: "TaoOfDow" <TaoOfDow@xxxxxxxxxxxxxx>
Cc: <omega-list@xxxxxxxxxx>
Sent: Tuesday, April 23, 2002 4:27 PM
Subject: Re: Code Conversion


> Can I post this to another list with your permission?
>
> ----- Original Message -----
> From: TaoOfDow <TaoOfDow@xxxxxxxxxxxxxx>
> To: phil <zxcv@xxxxxxxxxxx>
> Cc: <omega-list@xxxxxxxxxx>
> Sent: Tuesday, April 23, 2002 5:31 PM
> Subject: Re: Code Conversion
>
>
> > Dear Phil,
> >
> > I did a Google search for "floor traders support and resistance numbers"
> and
> > found
> >
>
http://www.sixer.com/y/s/education/tutorial/edpage.cfm?f=pivots.cfm&OB=indic
> ators
> >
> > I used the formulae shown there.
> >
> > I then coded that in ELA for a minute-based TS4 chart running in
realtime,
> and
> > my code is attached (Windows Notebook form, ie a .tst file).
> >
> > The code verifies and plots, but I haven't checked to see if it's
> accurate.
> >
> > Remember that TS4 can only plot 4 lines at a time, so I omitted the
Pivot
> > line.  If you want that, you'll need to write another Show-Me just for
it.
> >
> > Sincerely,
> >
> > Richard
> >
> >
> > phil wrote:
> >
> > > Hi List,
> > >
> > > Anyone willing to convert an indicator in TS6 format into ELA for TS4.
> It
> > > seems that when I go to verify it it's one small quirk after another.
> The
> > > solution is probably real easy but still beyond my knowledge of EL.
> > >
> > > It plots the floor traders support and resistance numbers on a daily
> chart.
> > > I wish to use it on intraday (minute and tick) charts in TS4.
> > >
> > > All cooperation is welcome.
> > >
> > > Thanks in advance,
> > >
> > > Phil
> >
>
>
> --------------------------------------------------------------------------
--
> ----
>
>
> > Var: Hi(0),
> > Lo(99999),
> > Mid(0),
> > Range(0);
> >
> > IF Date = CurrentDate THEN BEGIN
> > IF Time = Sess1StartTime + BarInterval THEN BEGIN
> > Hi = C;
> > Lo = C;
> > END ELSE BEGIN
> > IF C > Hi THEN Hi = C;
> > IF C < Lo THEN Lo = C;
> > END;
> > Mid = (Hi + Lo) / 2;
> > Plot1(Mid,"Mid");
> > Range = Hi - Lo;
> > IF Range >= 5 THEN BEGIN
> > IF C < Mid THEN BEGIN
> > Plot2(Lo + (0.25 * Range),"Q");
> > {IF C < (Lo + 0.25 * Range) THEN} Plot3(Lo,"HL");
> > END ELSE BEGIN
> > Plot2(Lo + (0.75 * Range),"Q");
> > IF C > (Lo + 0.75 * Range) THEN Plot3(Hi,"HL");
> > END;
> > END;
> > END;
> >
>
>