Re: Code for Pivot Line

["sunfiles" <sunfiles@xxxxxxx>]

Can you post the code for the pivot line?

Thanks,
Brian Oliver
sunfiles@xxxxxxx
Newport Coast, CA

----- Original Message -----
From: "TaoOfDow" <TaoOfDow@xxxxxxxxxxxxxx>
To: "phil" <zxcv@xxxxxxxxxxx>
Cc: <omega-list@xxxxxxxxxx>
Sent: Tuesday, April 23, 2002 3:31 PM
Subject: Re: Code Conversion


> Dear Phil,
>
> I did a Google search for "floor traders support and resistance numbers"
and
> found
>
http://www.sixer.com/y/s/education/tutorial/edpage.cfm?f=pivots.cfm&OB=indic
ators
>
> I used the formulae shown there.
>
> I then coded that in ELA for a minute-based TS4 chart running in realtime,
and
> my code is attached (Windows Notebook form, ie a .tst file).
>
> The code verifies and plots, but I haven't checked to see if it's
accurate.
>
> Remember that TS4 can only plot 4 lines at a time, so I omitted the Pivot
> line.  If you want that, you'll need to write another Show-Me just for it.
>
> Sincerely,
>
> Richard
>
>
> phil wrote:
>
> > Hi List,
> >
> > Anyone willing to convert an indicator in TS6 format into ELA for TS4.
It
> > seems that when I go to verify it it's one small quirk after another.
The
> > solution is probably real easy but still beyond my knowledge of EL.
> >
> > It plots the floor traders support and resistance numbers on a daily
chart.
> > I wish to use it on intraday (minute and tick) charts in TS4.
> >
> > All cooperation is welcome.
> >
> > Thanks in advance,
> >
> > Phil
>


----------------------------------------------------------------------------
----


> Var: Hi(0),
> Lo(99999),
> Mid(0),
> Range(0);
>
> IF Date = CurrentDate THEN BEGIN
> IF Time = Sess1StartTime + BarInterval THEN BEGIN
> Hi = C;
> Lo = C;
> END ELSE BEGIN
> IF C > Hi THEN Hi = C;
> IF C < Lo THEN Lo = C;
> END;
> Mid = (Hi + Lo) / 2;
> Plot1(Mid,"Mid");
> Range = Hi - Lo;
> IF Range >= 5 THEN BEGIN
> IF C < Mid THEN BEGIN
> Plot2(Lo + (0.25 * Range),"Q");
> {IF C < (Lo + 0.25 * Range) THEN} Plot3(Lo,"HL");
> END ELSE BEGIN
> Plot2(Lo + (0.75 * Range),"Q");
> IF C > (Lo + 0.75 * Range) THEN Plot3(Hi,"HL");
> END;
> END;
> END;
>