|
PureBytes Links
Trading Reference Links
|
It is a programming bug that eists in SC4, TS4, TS100, ...
It has to do with your graphic card driver that gets improper information
from Omega. If you change the settings for graphics hardware acceleration to
almost none (move the bar towards left, but not all the way to left), then
it shows as it should.
> -----Original Message-----
> From: MBLCTA@xxxxxxx [mailto:MBLCTA@xxxxxxx]
> Sent: Wednesday, February 02, 2000 7:00 PM
> To: omega-list@xxxxxxxxxx
> Subject: trendline tool bug_TS4
>
>
> I am using TS version 4 with Windows 98 and I have just
> noticed a problem
> with the trendline drawing tool. If I set the trendline to
> extend to the
> right or extend to the left, the extensions actually go up at
> an angle or
> down at an angle, instead of continuing the straight
> trendline line. The
> same thing happens when I select the parallel lines. The
> problem also exists
> with the Gann fan and the Speed fan. Those fans, when
> clicked to go to the
> right, actually go to the left.
>
> I don't know if this problem is because of the Y2K version of
> TS4 or because
> of Windows 98. When I used the pre-Y2K version on my old PC
> (Windows 95)
> these problems did not exist. Any insight to this situation would be
> appreciated.
>
> Thank you in advance.
>
|