|
PureBytes Links
Trading Reference Links
|
Go to the SystemBuilder, highlight the system and go to the signals tab, there
you will find the stops as 2000i interpreted the old stops, you may need to go
through the stops and change the inputs, or change the ones used. You will also
find the EOD Close as a signal rather than a radio button on the properties
dialog.
____________________Reply Separator____________________
Subject: Where are the stop setting in TS2000? Considering Upgrading?
Author: DPoiree@xxxxxxx
Date: 3/22/99 5:31 PM
Can anyone share where the stop settings are in TS2000?
For those who are debating doing an upgrade consider this: Four hours after
starting I have only one workspace re-created. Much to my surprise, workspaces
are not copied over in the upgrade process. This is documented in the
instructions though.
The frustrating thing is that my systems have "2%stop" printed on my trades
when the system doesn't even use stops. The on-line manual has a huge number
of stop subjects but I sure haven't found one that says how to set stop
settings. As for the paper "Learning to use EasyLanguage" manual, "Stop" isn't
even listed.
Sure, I could pick up the phone, call long distance only to be put on hold
interminably and eventually talk to a tech support person who, if I'm lucky
might be helpful... But alas, all I get is a busy signal...
Thanks much for any help!
Dan
I'ts a good thing for the dog that I don't take my anger out on him!
|