|
PureBytes Links
Trading Reference Links
|
Dan,
This was back when I had 7.2.1. I wrote a system with MACD and ADX with
and AND and an OR relationship for entry and exit. I set it up to work with
Optimization variables. When I ran it one system onb one stock, it would go
past 100% because I had an error in the logic. Then when I selected a group
of systems on one stock and I had also selected this system, it would still
continue
to run forever also. I fixed the logic in the system and then it started to
work fine.
Bill
----- Original Message -----
From: "Dan Harels" <harelsdb@xxxxxxxxxxx>
To: <metastock@xxxxxxxxxxxxx>
Sent: Tuesday, October 15, 2002 8:09 AM
Subject: Re: WTFO System Tester
>
> Bill,
>
> What aspect of your systems were "not valid"? Are Bill and I the only
ones
> that have upgraded to 8.0?
>
> Thanks,
>
> Dan
>
> >From: "billhebert" <billhebert@xxxxxxxxxxx>
> >Reply-To: metastock@xxxxxxxxxxxxx
> >To: <metastock@xxxxxxxxxxxxx>
> >Subject: Re: WTFO System Tester
> >Date: Sun, 13 Oct 2002 10:28:56 -0700
> >
> >I have had this condition occur when I have had systems that were not
> >valid.
> >Try running each system individually on a group of securities to make
sure
> >they
> >all complete successfully. If they do and you have the same problem.
Then
> >I
> >would contact Equis.
> >
> >-- B
> >----- Original Message -----
> >From: "Dan Harels" <harelsdb@xxxxxxxxxxx>
> >To: <metastock@xxxxxxxxxxxxx>
> >Sent: Saturday, October 12, 2002 10:01 PM
> >Subject: WTFO System Tester
> >
> >
> > >
> > > Has anyone fiddled with the new End of Day system tester? I am
running
> >a
> > > multi-variable optimization across multiple securities and something
> >isn't
> > > adding up. The number of runs should roughly equal the number of
> >variables
> > > times the number of steps times the number of securities. Metastock
> >gives
> > > this number in a dialog box and shows the status of the simulation in
> > > relation to the total number of runs required. When my simulation
gets
> >to
> > > to 100 percent, pressubably meaning all combinations have been tested,
> >the
> > > simulation keeps going. Is this a case of Equis giving more than 100
> > > percent or is there a bug in the tester. My current simulation is at
> >139
> > > percent of completion and it is still going. Does anyone have ideas
as
> >to
> > > why this is occurring?
> > >
> > > Thanks,
> > >
> > > Dan
> > >
> > >
> > >
> > > _________________________________________________________________
> > > Join the world's largest e-mail service with MSN Hotmail.
> > > http://www.hotmail.com
> > >
>
>
>
>
> _________________________________________________________________
> Send and receive Hotmail on your mobile device: http://mobile.msn.com
>
|