PureBytes Links
Trading Reference Links
|
Thanks for the info Gitanshu !
Could you or anyone of this list advice me about the following
:
1) I am looking for a Ethernet adapter for a
desktop computer which is
(proven) W2000 pro compatible (and
not too expensive).
tested by a list member and on
Microsoft compatible hardware list.
2) Off or on the list i would like to share
expirience/assistence of installing
hardware (like HP scanner, CD-RW etc)
for W2000 pro
and things like W2000pro and
networking , VMware.
3) Does anyone know if Sygate Homenetworking is W2000pro
compatible ?
Thanks
Theo
<BLOCKQUOTE dir=ltr
style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
----- Original Message -----
<DIV
style="BACKGROUND: #e4e4e4; FONT: 10pt arial; font-color: black">From:
<A title=onwingsofeagles@xxxxxxxxxxxxx
href="mailto:onwingsofeagles@xxxxxxxxxxxxx">Gitanshu Buch
To: <A title=metastock@xxxxxxxxxxxxx
href="mailto:metastock@xxxxxxxxxxxxx">metastock@xxxxxxxxxxxxx
Sent: Wednesday, February 21, 2001 1:57
PM
Subject: Re: e Signal and MS 7.03
You're always welcome - some corrections / further
suggestions, being sent to the listserv in general interest:
a/ I use the word "modem" below, it should alternatively
read "router" - the traffic cop that regulates the intra-network flow of
stuff. However, there is technology available today - cheap - that can
use your existing home phone lines to setup a network, as long as you install
the network interface cards on each pc/laptop, the modem will perform the same
job of getting connected to the isp & the rest of the intra-network stuff
is handled by the operating system. Difference in costs is a couple hundred
bucks.
b/ Home networking stuff can be found here - I don't
recommend anything specific since everyone's needs vary - suffice it to say
that every product below has been used by me at some point in the past few
years. Assuming everyone will migrate to broadband (cable/dsl) sooner or
later, the better thing to do is to bypass the router and work with solutions
that use existing hardware & wiring setups for the network - or go
wireless to keep portability intact.
<A
href="http://www.intel.com/anypoint/products/wireless/index.htm">http://www.intel.com/anypoint/products/wireless/index.htm for
wireless home networking
<A
href="http://www.netopia.com/equipment/products/">http://www.netopia.com/equipment/products/ for
routers
<A
href="http://www.3com.com/homeoffice/products/networking.html">http://www.3com.com/homeoffice/products/networking.html for
pc cards recognized/ used universally by most dsl/cable provider
software.
All sites also have some self-help guides.
Gitanshu
|