PureBytes Links
Trading Reference Links
|
AutoIt Editor
Its a monster, a beast of a program and a lot smoother setup than the MSK Indicator Builder...........
....and doesn't its GUI interface reminds you of.........................the MSKprogram?
Remember too to always look at the Status Bar {left bottom corner} for command's parameters etc.
since that the yellow Tips tell you a lot, but disappear (sometimes too) quickly.
AutoIt program - White Paper
Remember too not to forget to print out the original framed Helpfile{link was given in prev-mail}.
Since it is your "compass" in understanding and remembering the program issues+its commands.
Once printed, put the prints back to back in these special at any stationairy shop available plastic
bags(Europe=A4, US=Letter) and then put the bags in the specialy available small plastic binders.
Then you have a program manual, that's now always available/at hand.
In combination:
It's made all so Ooh-so very easy..............Good luck!.
cc - suggestions@xxxxxxxxx
(to check out the professional Editor interface, that could well be used for the MSK Indicator Builder
tomake formula building a lot easier and a lot quicker to learn, esp. when new to MSK).
Regards,
Ton Maas
ms-irb@xxxxxxxxxxxxxxxx
Dismiss the ".nospam" bit (including the dot) when replying.
Homepage http://home.planet.nl/~anthmaas
----- Original Message -----
From: "Walter Lake" <wlake@xxxxxxxxx>
To: <metastock@xxxxxxxxxxxxx>
Sent: zondag 11 juni 2000 12:32
Subject: Re: automating Metastock
> Hi Ton
>
> The AutoIt Script Editor looks very easy to understand. Thanks for you
> help.
>
> Best regards
>
> Walter
>
> ====================
>
> | There is also the AutoIt Editor(zipped 2.2Mb), with a Helping guide for
> the commands.
> | All of the AutoIt commands are listed on the left, and double clicking any
> one of them will
> | bring up a dialog with all of the options for that command. Most of the
> commands can be
> | figured out by just their name. For instance:
> | - 'WinActivate' sets the selected window as the active window
> | - 'WinGetActiveTitle' gets the title of the active window, etc...
> | It is available on the AutoIt home site or on the member creator's site
> | http://www.LKei.com
> |
>
> ----- Original Message -----
> From: "A.J. Maas" <anthmaas@xxxxxxxxx>
> To: "Metastock-List" <metastock@xxxxxxxxxxxxx>
> Sent: Saturday, June 10, 2000 9:19 AM
> Subject: Re: automating Metastock
>
>
> | > However ... where's the interface to record or write a script? I'm
> totally
> | > lost.
> | >
> |
>
>
|