Hello,
I intend to graphically display how a change in one
variable (say for instance heat) changes the system´s drawdown, ending equity
etc.
To do that, I´d need to get all results for a
backtest or optimization in one table to chose from there which one to display
in a ghraph.
Running an optimization "only" gives me the best
result. Same with backtest, which gives me the result of one specificically
selected parameter set.
To achieve the above described, would I thus have
to run various backtests while changing the, say, heat factor manually, then
save the result in MS Exel and have it displayed there?
Or did I overlook this feature in AB´?
Thanks
Markus
__________ Information from ESET Smart Security, version of virus signature database 4668 (20091207) __________
The message was checked by ESET Smart Security.
http://www.eset.com
__._,_.___
**** IMPORTANT PLEASE READ ****
This group is for the discussion between users only.
This is *NOT* technical support channel.
TO GET TECHNICAL SUPPORT send an e-mail directly to
SUPPORT {at} amibroker.com
TO SUBMIT SUGGESTIONS please use FEEDBACK CENTER at
http://www.amibroker.com/feedback/
(submissions sent via other channels won't be considered)
For NEW RELEASE ANNOUNCEMENTS and other news always check DEVLOG:
http://www.amibroker.com/devlog/
![]()
__,_._,___
|