Re: [amibroker] Subscript out of range

["Tomasz Janeczko" <groups@xxxxxxxxxxxxx>]

i = 0

is the ASSIGNMENT !

 

http://www.amibroker.com/guide/a_mistakes.html

Best regards,
Tomasz Janeczko
amibroker.com

----- Original Message -----

From: Markus Witzler

To: amibroker@xxxxxxxxxxxxxxx

Sent: Sunday, November 15, 2009 3:39 PM

Subject: [amibroker] Subscript out of range

Hello,

 

it´s probably just flawed thinking on my part, but I don´t understand why I get "subscript out of range" when I use the following if/else in CBT code:

 

if (i=0)

y=ATRexRounded[0];

else

y=ATRexRounded[i-1];

The code is embedded in a for loop, so all yalues for i=0, 1, ... barcount should be defined, right?

for (i = 0; i < BarCount; i++) //

{

}

Thanks

Markus

__________ Information from ESET Smart Security, version of virus signature database 4609 (20091115) __________

The message was checked by ESET Smart Security.

http://www.eset.com

__._,_.___

**** IMPORTANT PLEASE READ ****
This group is for the discussion between users only.
This is *NOT* technical support channel.

TO GET TECHNICAL SUPPORT send an e-mail directly to
SUPPORT {at} amibroker.com

TO SUBMIT SUGGESTIONS please use FEEDBACK CENTER at
http://www.amibroker.com/feedback/
(submissions sent via other channels won't be considered)

For NEW RELEASE ANNOUNCEMENTS and other news always check DEVLOG:
http://www.amibroker.com/devlog/

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___