Hello,
it´s probably just flawed thinking on my part, but
I don´t understand why I get "subscript out of range" when I use the following
if/else in CBT code:
if (i=0)
y=ATRexRounded[ 0];
else
y=ATRexRounded[i- 1];
The code is embedded in a for
loop, so all yalues for i=0, 1, ... barcount should be defined,
right?
for (i = 0; i < BarCount; i++) //
{
}
Thanks
Markus
__________ Information from ESET Smart Security, version of virus signature database 4609 (20091115) __________
The message was checked by ESET Smart Security.
http://www.eset.com
__._,_.___
**** IMPORTANT PLEASE READ ****
This group is for the discussion between users only.
This is *NOT* technical support channel.
TO GET TECHNICAL SUPPORT send an e-mail directly to
SUPPORT {at} amibroker.com
TO SUBMIT SUGGESTIONS please use FEEDBACK CENTER at
http://www.amibroker.com/feedback/
(submissions sent via other channels won't be considered)
For NEW RELEASE ANNOUNCEMENTS and other news always check DEVLOG:
http://www.amibroker.com/devlog/
![]()
__,_._,___
|