Re: [amibroker] Can't use Title statement in Procedure

[Keith McCombs <kmccombs@xxxxxxxxxxxx>]

Thank you.  That works for me.

Tomasz Janeczko wrote:

 

Sure you can but inside procedure all variables are by default LOCAL.
So you need to define it as GLOBAL first:

procedure yourproc()
{
global Title;
Title = .....
}

Keith McCombs wrote:
>
>
> The following works fine when it is inline, just before a plot
> statement, in main code.
> |*Title* = StrFormat("{{NAME}} - {{INTERVAL}} {{DATE}} Open %g, Hi %g,
> Lo %g, Close %g (%.1f%%) Vol %g, {{VALUES}}",
> *O*, *H*, *L*, *C*, SelectedValue(ROC(*C*, 1)), *V*)|;
>
> However, if I put it within a called procedure, with same plot
> statement, it is not executed, though the plot statement is. I've
> tried including O,H,L,C,V as called parameters in the procedure, but
> to no avail.
>
> Thanks for Help with this.
> -- Keith
>
>
>
>

__._,_.___

**** IMPORTANT PLEASE READ ****
This group is for the discussion between users only.
This is *NOT* technical support channel.

TO GET TECHNICAL SUPPORT send an e-mail directly to
SUPPORT {at} amibroker.com

TO SUBMIT SUGGESTIONS please use FEEDBACK CENTER at
http://www.amibroker.com/feedback/
(submissions sent via other channels won't be considered)

For NEW RELEASE ANNOUNCEMENTS and other news always check DEVLOG:
http://www.amibroker.com/devlog/

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___