Re: [amibroker] Re: Using peaks of volume

["Louis Préfontaine" <rockprog80@xxxxxxxxx>]

Hi,

I tried  

Bar0 = HHV (V,25);

instead of 

Bar0 = ValueWhen( HHVBars(H,25)==0, V);

and it seems to work.  However, it's kind of complicated.  Do you know any formula to avoid such big and non-relevant exchange of shares?

Thank you,

Louis

2008/7/1 Louis Préfontaine <rockprog80@xxxxxxxxx>:

Hi Graham,

What I am trying to do is to spot "fake" volume; that is, when there is a big exchange with a volume that is not relevant.

Here is what I tried (with your code):

Bar10 = ValueWhen( HHVBars(H,25)==0, Ref(V,-1) );
Bar01 = ValueWhen( HHVBars(H,25)==0, Ref(V,1) );
Bar0 = ValueWhen( HHVBars(H,25)==0, V);

Then I tried

Buy = Bar0>Bar01;//I just wanted to see it it worked on a selected ticker with the problem.

But it didn't work.  Bar 0 is the problematic bar and volume there is like 50 times greater than Bar 10 or Bar 01.  What is wrong with the code?

Thanks,

Louis

2008/7/1 Graham <kavemanperth@xxxxxxxxx>:

You could try this to get volume on bars before and after the hhv bar

Bar10 = valuewhen( hhvbars(h,25)==0, ref(v,-1) );
Bar01 = valuewhen( hhvbars(h,25)==0, ref(v,1) );

--
Cheers
Graham Kav
AFL Writing Service
http://www.aflwriting.com

2008/7/2 sidhartha70 <sidhartha70@xxxxxxxxx>:

> Use something like,
>
> BarsSince(HHV(V,25));
>
>
> --- In amibroker@xxxxxxxxxxxxxxx, "Louis Préfontaine" <rockprog80@xxx>
> wrote:
>>
>> Hi again,
>>
>> Another question is puzzling me. Tried to find the answer in the
> manual,
>> but didn't found' it. Luckily, this one should be easy for most
> experienced
>> users.
>>
>> I want to get the HHV of volume of a bar HHV (V,25) but then be
> able to
>> reference the bar before that or after that. Is it possible to get the
>> value of the HHV bar and then be able to get the date of that bar so
> I could
>> use it to determine what happened before or after that bar.
>>
>> E.g. Bar = HHV (V,25);
>> Bar > ref (Bar,-1);
>>
>> Etc.
>>
>> Thanks,
>>
>> Louis
>>

__._,_.___








Please note that this group is for discussion between users only.

To get support from AmiBroker please send an e-mail directly to 
SUPPORT {at} amibroker.com

For NEW RELEASE ANNOUNCEMENTS and other news always check DEVLOG:
http://www.amibroker.com/devlog/

For other support material please check also:
http://www.amibroker.com/support.html

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___