Graham
In my real system I noticed that I was getting buy signals on bars
that did not meet my conditions. I then ended up stringing the
elements of my conditions in one Buy statement. I then got the
correct buy signals. For example the buy statement from the example
below would become:
buy = Close > MA(close, 3) and Close>5 and Volume > 100;
the above buy statement produces correct buy signals but the
following wouldn't:
Cond1 = Close > MA(close, 3);
Cond2 = Cond1 and Close>5;
Cond3 = Volume > 100;
Buy = cond2 and cond3;
That is why I thought there must be an issue to using the condition
within another condition. Am I missing something?
ps. keep in mind the above example is used to illustrate my point may
not produce the error.
--- In amibroker@xxxxxxxxxps.com,
Graham <kavemanperth@...> wrote:
>
> In what way is the signal you get wrong?
>
> --
> Cheers
> Graham
> AB-Write >< Professional AFL Writing Service
> Yes, I write AFL code to your requirements
> http://www.aflwriting.com
>
>
> On 14/04/07, tipequity <l3456@xxx> wrote:
> > I get erroneous buy signal when I use embedded conditional
statement.
> > For example:
> > Cond1 = Close > MA(close, 3);
> > Cond2 = Cond1 and Close>5;
> > Cond3 = Volume > 100;
> > Buy = cond2 and cond3;
> > Is there something that I am missing?
>