There are a number of ways to go but one is
to draw the trendline with the trendline charting tool, assign a study id to
it, and then use the range marker bars to define the beginning and end
of the line. At that point, the number of bars is
simply:
endvalue(barindex()) -
beginvalue(barindex())
Bill
----- Original Message -----
Sent:
Saturday, April 07, 2007 2:04 PM
Subject:
[amibroker] bar counter
Hello,
I am trying to implement a bar counter - this
will indicate the number of bars between two ends of a trendline. The
trendline in Amibroker(when double clicked) shows the x and y position of
its ends, but I am not sure how to access this from a script. Any help in
this would be greatly appreciated.
To give a general idea of how
this is used, I have a system which relies on static bar counts from a
starting point. The attached chart for Thursday (for the SP500) shows how
turns are projected using 100 bar increments (on a 1min chart) starting
from a low (blue arrow). The chart was generated with Wave59. I want to do
the same using Amibroker.
Thank you in advance,
-VJ
Looking for earth-friendly autos?
Browse
Top Cars by "Green Rating" at Yahoo! Autos' Green Center.
![]()
No virus found in this incoming message.
Checked by AVG Free
Edition.
Version: 7.5.446 / Virus Database: 268.18.26/746 - Release
Date: 4/4/2007 1:09 PM