From: amibroker@xxxxxxxxxxxxxxx [mailto:amibroker@xxxxxxxxxxxxxxx] On Behalf Of Tomasz
Janeczko
Sent: Monday, October 03, 2005
2:35 AM
To: amibroker@xxxxxxxxxxxxxxx
Subject: Re: [amibroker] Can you
refresh only ONE chart instead of using the RefreshAll() Method
----- Original Message -----
Sent: Sunday, October
02, 2005 11:26 PM
Subject: [amibroker] Can
you refresh only ONE chart instead of using the RefreshAll() Method
Hi,
I’m
setting StaticVarSet in a
“parent”
chart
to set a global variable that affects “child”
charts. Awhile back Tomasz posted some code (my version
below) that used the “AB.RefreshAll() method to
automatically refresh all other charts. By automatically refreshing the
charts, StaticVarGet is executed in the
child charts, the global variable is retrieved, and the code in other charts is
run.
This
works nicely, with one exception – the refresh is very
slow. This is probably because some of my charts have some heavyweight
code that runs very slowly. (Normally I don’t use these
charts except for some entries and exits.) So here’s the
question…
Is
possible to refresh ONE target chart?
For
example the only child chart that I want to refresh is ChartID 1265. Is
it possible refresh JUST Chart 1265 from code?
Thanks
and regards,
Dan.
OldOverlayMktCapBool= StaticVarGet( "OverlayMktCapBool" );
if ( IsEmpty(OldOverlayMktCapBool)
OR OldOverlayMktCapBool !=
OverlayMktCapBool
)
{
StaticVarSet( "OverlayMktCapBool", OverlayMktCapBool);
AB = CreateObject("Broker.Application");
AB.RefreshAll();
// refreshes other charts
}
Please note that this group is for discussion between users only.
To get support from AmiBroker please send an e-mail directly to
SUPPORT {at} amibroker.com
For other support material please check also:
http://www.amibroker.com/support.html
SPONSORED LINKS
YAHOO! GROUPS LINKS