|
PureBytes Links
Trading Reference Links
|
Thanks for your links, i will check it out.
Regards
Thomas
www.tradingbasis.com
Tomasz Janeczko wrote:
No.
'&' operator has nothing to do
with addition. It is BINARY-WISE AND operator.
opposed to && (AND) which is
LOGICAL operator:
Best regards,
Tomasz Janeczko
amibroker.com
-----
Original Message -----
Sent:
Friday, September 30, 2005 2:25 PM
Subject:
Re: [amibroker] No more than 1 trade per day
Hi Tomasz,
you mean that & is the
same as +
and && is the same as AND
right ?
Regards
Thomas
www.tradingbasis.com
Tomasz Janeczko wrote:
Be careful:
& operator is binary-wise
AND.
AND (or && operator) is
logical AND.
Best regards,
Tomasz Janeczko
amibroker.com
-----
Original Message -----
Sent:
Friday, September 30, 2005 2:12 PM
Subject:
Re: [amibroker] No more than 1 trade per day
uups, there is one failure in the code.
Should be: Buy = Setup & Otpd;
Regards
Thomas
www.tradingbasis.com
Thomas Z wrote:
Hello Barry,
i also trade forex and have written such code a few months ago.
I have searched my files right now and have found the following code.
Check it out, i have not tested it right now.
Setup = your buy condition;
Tradedate = ValueWhen(setup,DateNum(),1);
LastTradedate = Ref(Tradedate,-1);
Otpd = Tradedate > Lasttradedate;//only
one trade per day
Buy = Setup;
Regards
Thomas
www.tradingbasis.com
Barry Seeger wrote:
How can I require that
there be no more than 1 trade per day?
I’m trading forex, on one
currency, and I want to require that if there has been a Buy or Sell
today, then take no more trades today.
Something like: Buy =
conditions AND DayofWeek() > or < DayofWeek() for last Buy or
Sell, but I don’t know how to write it.
The “or <” would allow
for Mondays.
Thanks for your help.
Please note that this group is for discussion between users only.
To get support from AmiBroker please send an e-mail directly to
SUPPORT {at} amibroker.com
For other support material please check also:
http://www.amibroker.com/support.html
SPONSORED LINKS
YAHOO! GROUPS LINKS
|
|