|
PureBytes Links
Trading Reference Links
|
--- In amibroker@xxxxxxxxxxxxxxx, "Barry Scarborough" <razzbarry@xxxx>
wrote:
>
> When I am running back test I change parameters a number of times
> trying to find a good combination. But it is easy to forget which
> parameters went with a specific Report. It would be very helpful if
> the parameters were exposed on one of the report windows. But I
> cannot figure out how to code that. Is it possible to set the param
> values either in the Settings tab or Formula tab of the Report? If
> so, how do we code it in AFL?
>
> Thanks,
> Barry
Good point, its currently impossible to tell which "params" one used
on a given report (i.e., values picked from Param before running
backtest).
The report does show some of the "settings" that were used which can
be specified via code or GUI. But the report doesn't tell us at all
which param values were used.
I'd send a wish list request to AmiBroker about this issue.
Regards,
JD
------------------------ Yahoo! Groups Sponsor --------------------~-->
Has someone you know been affected by illness or disease?
Network for Good is THE place to support health awareness efforts!
http://us.click.yahoo.com/Rcy2bD/UOnJAA/cosFAA/GHeqlB/TM
--------------------------------------------------------------------~->
Please note that this group is for discussion between users only.
To get support from AmiBroker please send an e-mail directly to
SUPPORT {at} amibroker.com
For other support material please check also:
http://www.amibroker.com/support.html
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/amibroker/
<*> To unsubscribe from this group, send an email to:
amibroker-unsubscribe@xxxxxxxxxxxxxxx
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|