|
PureBytes Links
Trading Reference Links
|
Hango,
TS2ki is a frustrating program. You should select all the symbols
right now by holding a right click to highlight the boxes black then
left click and choose connect symbol. They should show connected on
the symbol page all the time data or no data. On the performance page
you will see data coming in when the market opens for some of your
symbols. Restarts of the GS and reboots of the computer are always
good for TS2ki.
Jimmy
Jimmy
Thanks for your kind reply.
Before reading your reply, I was sure that eSignal's Data Manager was
connected but not sure on the GlobalServer. Following your suggestions, I
did check the [Performance] page in GlobalServer. It shows as, DataFeed: DBC
Online, Connect status: initialized, etc. It appears that everything is OK
as well.
I was frustrated with the "Not Connected" status in the <Real-Time Status>
column on the [Symbol Portfolio] page of GlobalServer. Maybe I misunderstood
what that "Not Connected" status behind each symbol really means? After all,
my installation was taken place after the market session on Friday night.
In few hours, the Globex will resume nightly trading. By that time, if I
don't receive any data for SP U7 and NQ U7, then I would switch back to my
TS4 + Dynastore + eSignal setting.
Hango
----Original Message Follows----
From: Jimmy Snowden <jhsnowden@xxxxxxxxxxxxx>
Reply-To: Jimmy Snowden <jhsnowden@xxxxxxxxxxxxx>
To: Omega-List <omega-list@xxxxxxxxxx>
Subject: Re[3]: Vista & TS2000i
Date: Sun, 15 Jul 2007 09:23:55 -0500
Hango,
In the Global Server performance tab you show Connect status "Not
Connected"? If so what does it show above that under DataFeed? I
should be DBC Online. If not click on tools and run set up again. BE
SURE you choose to save your symbols and data. If you show DBC
Online and you show connected then go to the Symbol Portfolio and
right click and hold the right click as you highlight the symbols and
drag to the end of the list. Then left click and choose connect
symbol. If all this fails be sure esignal data manager show to be
connected in it's little window. I think that is all there is that
can be wrong. Well you could turn the firewall off just to be sure it
isn't the problem. How many firewalls do you have. It is best to
only run one firewall.
Jimmy
|