|
PureBytes Links
Trading Reference Links
|
It has been brought to my attention that Alexis Montenegro
does NOT work for esignal- but is a major helpful contributor
to the bulletin-board at Esignal, posting very helpful information
regarding TS2ki issues.
(http://forum.esignalcentral.com)
Esignal should be paying him something,
I am not the only one that has given him 'Guru' status for his
contributions- evident upon reading the posts there.
Rewards greater than $'s present themselves in many forms.
Thank you again Alex,
Marc Miller
----- Original Message -----
From: "marc miller" <marcmiller@xxxxxxxxx>
To: <omega-list@xxxxxxxxxx>; "Jimmy Snowden" <jhsnowden@xxxxxxxxxxxxx>
Sent: Sunday, February 13, 2005 8:54 PM
Subject: Re: Data not showing up on newly added session
> Thanks Jimmy,
> I contacted Alexis Montenegro at Esignal.
> He is the TS2ki Guru there.
> I was instructed to change the 'Start' time for the session
> to Saturday at 15:01, with the session end of Sunday at 14:58 (I'm on
> Pacific time)
> Now it's working- all data is plotting.
> Amazing.
> I did try the checking and un-checking of the reset boxes.
> I do think that I have used what you had suggested in some manner (notice
> think)
> with the emini situation at one point (back in the day) and it did solve
> something.
> Thanks,
> Marc
>
> ----- Original Message -----
> From: "Jimmy Snowden" <jhsnowden@xxxxxxxxxxxxx>
> To: "Marc Miller" <marcmiller@xxxxxxxxx>; "Omega-List"
> <omega-list@xxxxxxxxxx>
> Sent: Sunday, February 13, 2005 4:13 PM
> Subject: Re: Data not showing up on newly added session
>
>
> > When you get to messing with sessions sometimes you have to leave one
> > unchecked to get it to plot. Unchecked in the GS under Sessions.
> > Depends on how you have them setup and the crossing of midnight I
> > think. If the data comes in then it is saved no matter the check
> > marks. Actually I think (notice think) any data that comes in is
> > saved no matter the sessions settings.
> >
> > I got tired of it in eminis and setup sessions for Sunday until Monday
> > at 15:15 CST then next session 15:30 Monday until Tuesday 15:15 then
> > Tuesday 15:30 ... Works great but some code might get fried if it
> > depends on sessions.
> >
> > Jimmy
> >
> > I have added a Sunday 09:00 to 14:58 (I'm on Pacific time)
> > (see attached .png image)
> > Just above the Sunday 15:01 to Monday 14:58 session.
> > [I had forgot to add this early Sunday session when first setting up
forex
> > symbols in the GS]
> > Now the GS is getting the data just fine, as I have checked in the edit
> data
> > tab- it's there-
> > but it is NOT showing up in any charts.
> > Charts DO show data starting at 15:01 pacific- but no data is shown
before
> > then-
> > even though it is being collected.
> >
> > Thanks,
> > Marc Miller
> >
> >
> >
>
>
>
|