|
PureBytes Links
Trading Reference Links
|
Problem solved - After reading the sticky posts in their forum. I finally
found that for Esignal 7.6 you had to have the lastest version of the
plugin. build 4081.
-----Original Message-----
From: Dr War [mailto:drwar@xxxxxxxxxxx]
Sent: Saturday, August 07, 2004 1:23 PM
To: Jimmy; Omega-List
Subject: RE: GS Esignal
Well that solved the Esignal statup problem but did not solve my Esignal
Plugin problem. When I open the plugin
link to download from esignal there is no data vendor listed and that
inhibits me from downloading. Anyone have
any ideas ?
-----Original Message-----
From: Dr War [mailto:drwar@xxxxxxxxxxx]
Sent: Saturday, August 07, 2004 1:14 PM
To: Jimmy; Dr War; Omega-List
Subject: RE: GS Esignal
Jimmy
thanks for the info. I think I found it. There is a bit of confusiion in the
install documentation where you
you have a choice to select DBC subsever or DBC online Subserver. If you
highlite DBC Subserver it tells
you that it supports among other things esignal online. And it fact it does,
witnessed by the fact if Esignal
is started GS picks up on that and runs fine. However its DBC online
Subserver that needs to be selected if GS is going to start esignal. I
believe the first time thru I jumped to DBC subserver read the note and
didn't even see their was another better choice.
Jerry
-----Original Message-----
From: Jimmy [mailto:jhsnowden@xxxxxxxxxxxxx]
Sent: Saturday, August 07, 2004 11:31 AM
To: Dr War; Omega-List
Subject: Re: GS Esignal
Jerry,
Same way I did it. Then when all was working I ran the install for the
Plugin.
I would reinstall TS2ki on top of this install and be very careful when
you get to the DBC online section the correct one to choose gives you
a second page with three options I believe. One clearly shows Esignal
online. My guess is you were zipping though the install and might have
clicked the wrong one. If I have misnamed the DBC online or Esignal
online then I'm sorry but I don't remember exactly what they are
called. I do know if you don't see a list of three things that this
part of the install works for then you have the wrong DBC window and
need to go back.
I wont tell you where I learned that mistake.
Jimmy
Saturday, August 7, 2004, 10:21:23 AM, you wrote:
DW> Jimmy or anyone
DW> Here is my problem. I re-installed ts on a new hard drive. I went thru
and
DW> installed Esignal thru the TS CD but that installs an older verison. I
then
DW> just installed over it the newer version which I had. But when GS fires
up
DW> it says it cannot find Esignal. If I start esignal and then start GS
DW> everything is ok because it finds it running. But the fact it cannot
find
DW> and start it by itself is leading to other problems such as trying to
use
DW> the Esignal Plugin for TS.
DW> Jerry
--
Best regards,
Jimmy mailto:jhsnowden@xxxxxxxxxxxxx
|