|
PureBytes Links
Trading Reference Links
|
Bob,
Interesting. Does the four deep nesting apply to other loop statements
also? If...then, While..., etc?
Thanks,
Bill
----- Original Message -----
From: Bob Fulks <bfulks@xxxxxxxxxxxx>
To: Gene Pope <gene@xxxxxxxxxxxxx>; <omega-list@xxxxxxxxxx>
Sent: Wednesday, October 02, 2002 11:03 AM
Subject: Re: Array Question
> At 12:34 PM -0400 9/30/02, Gene Pope wrote:
>
> >Am I correct in assuming that when you run a verified indicator or
strategy,
> >and you get an Array out of bounds type error, that this error can be
caused
> >by an array call anywhere in the code, and not necessarily where you
put
> >Print Debug statements to try to pin it down?
> >
> >In other words, if your Debug statements show that you stopped
executing at
> >Line 20, is it possible to get an array error caused by an array call
at
> >line 40?
> >
> >Sure seems that way... any other undocumented Array warnings I should
be
> >aware of?
>
> There are a lot of "warnings". I can recall a couple.
>
> I just spent two days debugging one.
>
> I had forgotten that TradeStation only allows you to nest four "for
> loops" and my code used five. This gave me continuous "Array out of
> bounds" errors for some unknown reason. (It was not possible in the
> code I was using.) Of course, there was no error message to tell me
> of the four-loop limit so I had to search for the problem after I
> remembered this.
>
> Also, TS4.0 only works with up to two dimensions on an array. There
> are no error messages if you use more than two - it just doesn't work
> correctly. TS2000i seems to have increased this limit to some higher
> number.
>
> The best debugging method I have found is to comment out sections of
> code - narrowing the excluded section until the offending code is
> isolated. This can end up as a loop or even a single statement which
> has nothing to do with the error message. Then wrack your brain to
> figure out what might be causing the problem. As in your case, the
> print statements that printed up to the point of the error made no
> sense - the printed sequence was not possible in any logical way.
>
> In my case, I replaced one of the "for loops" with a "while loop" and
> the code worked perfectly.
>
> Extremely frustrating. I pity the poor guy with little software
> debugging experience who tries to use TradeStation for anything
> complex...
>
> Bob Fulks
>
>
>
>
|