PureBytes Links
Trading Reference Links
|
I had the same problem a while back and installed a 2nd Parallel Port for
the TS Dongle --
After doing that, you need to designate LPT2 when running the SSIACT
program to determine the new SSI_ACT parameters for your AUTOEXEC.BAT file --
______________________________________
At 01:14 PM 11/16/2001 -0500, you wrote:
>Greetings,
>
>The TS4 security block is causing communication problems with my HP
>OfficeJet 600 All-in-One. I have performed all of the steps recommended
>in the Tradestation knowledge base. It seems that the HP600 doesn't work
>well if there's anything else attached to the printer port. If I
>disconnect the printer from the security block and re-start, I'm OK,
>that is, I can get in to TS4. If the printer is connected, I get a
>"missing security block" message, and boy, does it screw up my printer!
>
>If you have been over this terrain, could you drop me a line? The
>computer involved is a Dell Dimension XPS T500.
>
>Much obliged and best regards,
>Philip
|