PureBytes Links
Trading Reference Links
|
try using cross or point plots instead of lines.
cc
----- Original Message -----
From: "Ron Augustine" <RonAug@xxxxxxxxxxxxx>
To: <omega-list@xxxxxxxxxx>
Cc: <shraga@xxxxxxxxxxxx>
Sent: Sunday, November 11, 2001 4:16 PM
Subject: Re: Charting indicator part-time
> I'm not familiar with versions after TS-4, but it sounds like you have
your
> "Plot Setting Type" set to "Line" which will plot a line between each
point
> that you calculate. If you only want to see a plot for each new
calculated
> value, change the Plot Type to "Point" --
> __________________________________
> At 08:54 PM 08/12/2001 +0200, you wrote:
> >Hello everyone,
> >
> >I`m trying to tell EL to code a certain indicator, but only at certain
> >times, For example:
> >
> >If Percentr(25) > 50 then begin
> >
> > plot xaverage(close,50)
> >end;
> >
> >The problem is that TS charts the indicator ALWAYS, not only when
Percentr
> >is bigger than 50.
> >
> >Any ideas?
> >
> >Philip
> >
>
|