|
PureBytes Links
Trading Reference Links
|
If you didn't run the SSIACT.EXE program after installing the new Parallel
Port, you will need to do so by executing the following statement from a DOS
prompt outside of Windows (assuming your OMEGA directory is on drive "C") --
C:\OMEGA\PROG\DRIVERS\NT\SSIACT.EXE
If it recognizes the security block, it will produce a result similar to:
SET SSI_ACT=2,2,15
Edit the designated version of the above statement into your AUTOEXEC.BAT
file and re-boot the machine.
______________________________________
At 03:23 AM 11/27/98 -0200, you wrote:
>Hi Netters,
>
>My security block sometimes says: "security block missing", a
>small gray window different from the large one saying "security
>block not found".
>If I press it a little more, or if I jiggle it a bit everythings works fine
>again. The problem is that I installed a new paralell port just to try
>to get rid of this, but it did not go away.
>
>Do any of you have similar problems? Do you think my security
>block is faulty and should be replaced? Its is not a matter of
>software is a matter of being luck with its fit in the printer port
>which is brand new.
>
>Yhank you all for your time,
>Sincerely
>Alfredo
>
>
|