Fw: Results of Optomization to CSV file

["Peter Gibson" <Peter_Gibson@xxxxxxxxxxxxxx>]

Thanks for the insight...any ideas for a work-around?

One idea I had was to compare the value of the parameters from the last time
the lastbaronchart condition was met.  However on each optomization all
variables are reset so I think I would have to use global variables.

Anyone have any more elegant ideas for writing optomization results to a CSV
file without the result of the last optomization showing up twice?

 -----Original Message-----
From: Bill Vedder <bved01@xxxxxxx>
To: Peter Gibson <Peter_Gibson@xxxxxxxxxxxxxx>
Cc: omega-list@xxxxxxxxxx <omega-list@xxxxxxxxxx>
Date: August 21, 1998 6:51 PM
Subject: Re: Results of Optomization to CSV file


>Peter Gibson wrote:
>>
>> I am attempting to send results of optomization directly to a CSV file.
>> This is the code I am using just to see if I can get the thing to work:
>>
>> If LastBarOnChart then begin
>>      NP=NetProfit;
>>      FileAppend( "d:\data\xtra\equity.csv",
>>      Sym+","+
>>      numtostr(Date,0)+","+
>>      numtostr(Param1,0)+","+
>>      numtostr(Param2,0)+","+
>>      numtostr(Param3,0)+","+
>>      numtostr(Param4,0)+","+
>>      numtostr(Param5,0)+","+
>>      numtostr(NP,0)+","+
>>      newline);
>> end;
>>
>> Works OK except for the last value of the optomization the line is
printed
>> twice - so for each future I get an extra line - any ideas?
>
>Peter,
>
>Your code is fine. For some reason TS repeats the final optimization run
>in a series. If you specify to test PARAMETERX from 1 to 5 by 1, you'll
>see that TS will perform 6 runs, not 5 as you'd expect.
>
>Maybe some of the experts can comment as to why this happens. Or maybe
>some of the Omega folks can comment.
>
>Regards,
>Bill Vedder
>
>
>
>