[amibroker] Vbscript to run an exploration

["donpickdonpick" <donpick1@xxxxxxxxx>]

I have searched and searched.  I cannot find sample code showing how to run an exploration using vbscript.

Recently an article was published in TASC showing a modified ATR stop system written in AFL.  It has two parameters in it.

I am fairly good at programming in VBSCRIPT.  I understand how fso works. 

May be someone could send me some code showing how to run an exploration in a vbs file where the parameters are obtained from some sort of file (a test file would be fine).  

Thank you




------------------------------------

**** IMPORTANT PLEASE READ ****
This group is for the discussion between users only.
This is *NOT* technical support channel.

TO GET TECHNICAL SUPPORT send an e-mail directly to 
SUPPORT {at} amibroker.com

TO SUBMIT SUGGESTIONS please use FEEDBACK CENTER at
http://www.amibroker.com/feedback/
(submissions sent via other channels won't be considered)

For NEW RELEASE ANNOUNCEMENTS and other news always check DEVLOG:
http://www.amibroker.com/devlog/

Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/amibroker/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/amibroker/join
    (Yahoo! ID required)

<*> To change settings via email:
    mailto:amibroker-digest@xxxxxxxxxxxxxxx 
    mailto:amibroker-fullfeatured@xxxxxxxxxxxxxxx

<*> To unsubscribe from this group, send an email to:
    amibroker-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/