[amibroker] loop question

[Noah Bender <knowabender@xxxxxxxxx>]

Dear all,

 

I understand I can't reference an array in an if statement and I should probably write a loop to get the value of signallow5 in the code below. I am still learning how to write  loops. Can anyone post a sample loop as to how I could reference the signal low in my IF statement

 

 

Low5 = LLV(L,5);

Signallow5=Ref(Low5,-1);

 

if (low[barcount-1] <signallow5)

{ 

           ibc.PlaceOrder( Name(), "Sell",IBPosSize, "MKT", 0, 0, "GTC", True );

}

 

thanks

noah

__._,_.___

**** IMPORTANT PLEASE READ ****
This group is for the discussion between users only.
This is *NOT* technical support channel.

TO GET TECHNICAL SUPPORT send an e-mail directly to 
SUPPORT {at} amibroker.com

TO SUBMIT SUGGESTIONS please use FEEDBACK CENTER at
http://www.amibroker.com/feedback/
(submissions sent via other channels won't be considered)

For NEW RELEASE ANNOUNCEMENTS and other news always check DEVLOG:
http://www.amibroker.com/devlog/

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___