Re: [amibroker] Re: MACD Signal Value

[apforex@xxxxxxxxx]

see this

apforex,

So when AMIBroker is going through all the bars of data loaded for a 
symbol the for loop below really in a sense only runs for the current 
bar that AMIBroker is processing?

If this is the case can you just state 
if( macd_signal[0] > 0) //Is this always the 'current' bar?
{
}
Thank you,
Patrick
  

__._,_.___

Please note that this group is for discussion between users only.

To get support from AmiBroker please send an e-mail directly to
SUPPORT {at} amibroker.com

For NEW RELEASE ANNOUNCEMENTS and other news always check DEVLOG:
http://www.amibroker.com/devlog/

For other support material please check also:
http://www.amibroker.com/support.html

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___