|
PureBytes Links
Trading Reference Links
|
Thanks guys, I'll try those suggestions.
Bernard
--- In amibroker@xxxxxxxxxxxxxxx, Graham <kavemanperth@xxx> wrote:
>
> How about the settings for position size on bar volume limitation
(AA settings)
>
> --
> Cheers
> Graham
> AB-Write >< Professional AFL Writing Service
> Yes, I write AFL code to your requirements
> http://www.aflwriting.com
>
>
> On 28/05/07, David Smith <david.smith5@xxx> wrote:
> >
> > Have you turned off "allow position size shrinking"?
> >
> > Perhaps alternatively you could set the minimum position value
as well.
> >
> > Dave
> >
> > > bernardedmond01 <bernardedmond01@xxx> wrote:
> > >
> > > Is that correct? It doesn't seem to work that way when I run
it.
> > > I specify each position size as $50,000 but I get partial
fills.
> > > When I look to see the actual trade in chart form, I see
volume was
> > > down that day...The position size in the report then shows the
lower
> > > position size.
> > >
> > > --- In amibroker@xxxxxxxxxxxxxxx, "Ara Kaloustian" <ara1@>
wrote:
> > > >
> > > > Bernard,
> > > >
> > > > Look at positionSize in help.
> > > >
> > > > You can specify a fixed amount of $ for each trade. Only
time you
> > > can get a
> > > > smaller amount would be if you did not have adequate funds
left
> > > for full
> > > > position
> > > >
> > > > ----- Original Message -----
> > > > From: "bernardedmond01" <bernardedmond01@>
> > > > To: <amibroker@xxxxxxxxxxxxxxx>
> > > > Sent: Sunday, May 27, 2007 4:47 PM
> > > > Subject: [amibroker] Position Size problems
> > > >
> > > >
> > > > > Apologies if this has been covered elsewhere, I couldn't
find any
> > > > > references here of past threads...
> > > > >
> > > > > I want to make sure that every position I enter has a full
> > > position
> > > > > size (which for my purposes is $50,000).
> > > > > When I run the backtest, I see that on some occasions I
enter a
> > > trade
> > > > > but it has a position size of say $5,000. I'm guessing
this is
> > > because
> > > > > it had lower volume that day (correct?).
> > > > > The reality is, I would pass on that trade.
> > > > > I tried to fix this by having a MA(V,50)>100000 but this
doesn't
> > > > > always work since volume may be very volatile.
> > > > > Can I say in my formula, buy if these conditions are met
and
> > > this is
> > > > > the PS but don't take the trade if PS would be less than
what
> > > I've
> > > > > stipulated?
> > > > > TIA,
> > > > > Bernard
> > > > >
> > > > >
> > > > >
> > > > > Please note that this group is for discussion between
users only.
> > > > >
> > > > > To get support from AmiBroker please send an e-mail
directly to
> > > > > SUPPORT {at} amibroker.com
> > > > >
> > > > > For NEW RELEASE ANNOUNCEMENTS and other news always check
DEVLOG:
> > > > > http://www.amibroker.com/devlog/
> > > > >
> > > > > For other support material please check also:
> > > > > http://www.amibroker.com/support.html
> > > > >
> > > > > Yahoo! Groups Links
> > > > >
> > > > >
> > > > >
> > > >
> >
> > David Smith
> > 55 OLIVIA PLACE
> > PULLENVALE, 4069
> > Ph: 3374 4819
> > Mob: 0411 120 952
> >
> >
> > Please note that this group is for discussion between users only.
> >
> > To get support from AmiBroker please send an e-mail directly to
> > SUPPORT {at} amibroker.com
> >
> > For NEW RELEASE ANNOUNCEMENTS and other news always check DEVLOG:
> > http://www.amibroker.com/devlog/
> >
> > For other support material please check also:
> > http://www.amibroker.com/support.html
> >
> > Yahoo! Groups Links
> >
> >
> >
> >
>
Please note that this group is for discussion between users only.
To get support from AmiBroker please send an e-mail directly to
SUPPORT {at} amibroker.com
For NEW RELEASE ANNOUNCEMENTS and other news always check DEVLOG:
http://www.amibroker.com/devlog/
For other support material please check also:
http://www.amibroker.com/support.html
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/amibroker/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/amibroker/join
(Yahoo! ID required)
<*> To change settings via email:
mailto:amibroker-digest@xxxxxxxxxxxxxxx
mailto:amibroker-fullfeatured@xxxxxxxxxxxxxxx
<*> To unsubscribe from this group, send an email to:
amibroker-unsubscribe@xxxxxxxxxxxxxxx
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|