|
PureBytes Links
Trading Reference Links
|
You could just add a condition that the next buy cannot be in the same
hour as the last sell.
--
Cheers
Graham
AB-Write >< Professional AFL Writing Service
Yes, I write AFL code to your requirements
http://e-wire.net.au/~eb_kavan/ab_write.htm
On 23/07/06, nightscalper <nightscalper@xxxxxxxx> wrote:
> Hello all,
>
> for backtesting purposes I want to define "nBarsWait" like this:
>
> nBarsWait = 60 - Minute();
> ApplyStop(stopTypeLoss,stopModePoint,nStop,1,False,nBarsWait);
> ApplyStop stopTypeProfit,stopModePoint,nTarget,1,False,nBarsWait);
>
> But the applystop function does not allow me to do this.
>
> My aim is, that, after a Buy signal was previously generated
> and the position is closed by applystop function, I want my
> trading system to wait until the next full hour starts until
> it is ready again for opening the next Buy position.
>
> In realtime trading it should work (see fomula below) but for
> backtesting with historical data, the applystop function does
> not accept referencing to the bar´s minute "Minute()".
>
> Will appreciate any help.
> Thanks and regards.
> Robert
>
> _________________________________________________________________
> Time = Now(4);
> CurMinute = int(Time/100%100);
> nBarsWait = 60 - CurMinute;
> ApplyStop(stopTypeLoss,stopModePoint,nStop,1,False,nBarsWait);
> ApplyStop stopTypeProfit,stopModePoint,nTarget,1,False,nBarsWait);
> _________________________________________________________________
>
>
>
>
>
>
>
>
>
>
>
>
>
> Please note that this group is for discussion between users only.
>
> To get support from AmiBroker please send an e-mail directly to
> SUPPORT {at} amibroker.com
>
> For other support material please check also:
> http://www.amibroker.com/support.html
>
>
> Yahoo! Groups Links
>
>
>
>
>
>
>
|