Stops are Sells with different codes. If
you have:
Filter = Buy or Sell;
You should be getting nBar stops too.
From Help:
Depending on kind of the stop various values
are written back to sell/cover array to enable you to distinguish if given
signal was generated by regular rule or by stop.
1 - regular exit
2 - max. loss
3 - profit target
4 - trailing
5 - n-bar stop
6 - ruin stop
-----Original Message-----
From: amibroker@xxxxxxxxxxxxxxx
[mailto:amibroker@xxxxxxxxxxxxxxx] On Behalf
Of Mark H
Sent: Sunday, April 16, 2006 11:00
To: amibroker@xxxxxxxxxxxxxxx
Subject: [amibroker] where are the
stop alerts?
I am moving my system from
Wealth-lab to AmiBroker. My system is basically a long only EOD system. Every
night I download quotes and run the Wealth-lab simulator against 600 stocks. It
generates a list of alerts with priority (similar to PositionScore in AB). The alerts
include Buy/Sell/Stop(n-bar) signals. I then enter Sell orders for all sell and
stop signals to sell the open next day. I sort the buy orders by
priority and enter the top ones to buy the open next day. The number of
buy orders and sizes of them are calculated based on the total equity
today and the number of sell orders the next day.
With AmiBroker, I can get a
list of Buy/Sell signal and their PositionScores using Exploration. However, I
have not found a way to list all n-bar Stop signals on the same screen. Maybe I
can find a way to use "filter" value to include those stops. Any
suggestion is appreciated.
Please note that this group is for discussion between users only.
To get support from AmiBroker please send an e-mail directly to
SUPPORT {at} amibroker.com
For other support material please check also:
http://www.amibroker.com/support.html
SPONSORED LINKS
YAHOO! GROUPS LINKS