|
PureBytes Links
Trading Reference Links
|
Yep, not your installed memory. I have 1.5Gb and AB runs fine.
Just a thought... Try turning Off the code switch and then turning off HyperThreading (I think that's an option), then turn off both.
Also, have you checked your page file size? At 2Gb of memory, it should be set to about 3Gb.
I can't think of anything else.
Good luck,
Dan.
-------------- Original message --------------
From: "Mark Keitel" <mkeitel@xxxxxxxxxxxxxxx>
2gb of memory, think it is like 533 speed, Hyper thread machine, plus I changed the Microsoft code switch to allow 3gb of memory and page memory is maxed out too
That is not the issue, has to do with settings inside AB I would think
From: amibroker@xxxxxxxxxxxxxxx [mailto:amibroker@xxxxxxxxxxxxxxx] On Behalf Of dan_public@xxxxxxxxxxx
Sent: Tuesday, December 20, 2005 7:52 PM
To: amibroker@xxxxxxxxxxxxxxx
Subject: Re: [amibroker] OUT of MEMORY code
AB and eSignal are memory "intensive". With EOD data (i.e., no live datafeed), I've had AB use more than 1/2 Gb of memory after an exploration.
How much memory does your system have? If less than 1Gb, consider upgrading.
-------------- Original message --------------
From: "aajohnah" <aajohnah@xxxxxxxxxxxxxxx>
I am trying to run an explore on my whole data base now and am getting an out of memory though it says
E-signal out of memory and AB is locked up
Any suggestion?
Thank you
Mark
Please note that this group is for discussion between users only.
To get support from AmiBroker please send an e-mail directly to
SUPPORT {at} amibroker.com
For other support material please check also:
http://www.amibroker.com/support.html
YAHOO! GROUPS LINKS
|