Re: [amibroker] Running Multiple ATCs

["Joe Landry" <jelandry@xxxxxxxxxxxxx>]

Dave - I believe you have the Clearwater Conference CDs from Werner Gansz's last presentation.

In the section where he builds composites for each Rydex fund out of the component stocks, he

has an AFL that runs through the watchlists.  Basically he's building an equity curve for each

Rydex fund based on it's holdings with a watch list for each fund.

 

Probably what you're asking is not as complex as that but it would serve as a prototype.

Best regards

JOE  

----- Original Message -----

From: David Fitch

To: amibroker@xxxxxxxxxxxxxxx

Sent: Thursday, December 08, 2005 6:38 PM

Subject: [amibroker] Running Multiple ATCs

I have several composites that use different watch lists or industry groups. Right now I run them for each individual watch list  or group. For example I have several composites that I scan with Russell 2000 watch list, another set that scan with all stocks, another that scans with Russell 3000 watch list.  Is it possible to set up one scan that will change watch lists or industry groups?

Can someone tell me what I need to do?

 

Nonprogrammer needs hand holding!

 

Thanks

Dave

 

 

 

Please note that this group is for discussion between users only.

To get support from AmiBroker please send an e-mail directly to
SUPPORT {at} amibroker.com

For other support material please check also:
http://www.amibroker.com/support.html

SPONSORED LINKS

Investment management software	Real estate investment software	Investment property software
Software support	Real estate investment analysis software	Investment software

---

YAHOO! GROUPS LINKS

•  Visit your group "amibroker" on the web.
   
•  To unsubscribe from this group, send an email to:
   amibroker-unsubscribe@xxxxxxxxxxxxxxx
   
•  Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

---