|
PureBytes Links
Trading Reference Links
|
Where I've seen the message is when repeating R/T scans -- e.g. an
exploration w/app. 1,000 symbols that I run pre-market every couple
of minutes. I do not use "wait for backfill" on those scans because I
am using the getRTData() function. In the end, it doesn't seem to
effect anything in AB -- I was just concerned eSignal would start to
show a problem with the account.
I am going to try to setting that Tomasz mentioned in a reply and see
if the problem goes away. I will post the results.
Gordon
--- In amibroker@xxxxxxxxxxxxxxx, "Bob Jagow" <bjagow@xxxx> wrote:
> Hello eSignal users:
> I installed 4.60.1 Pro and have the basic [100-symbol] eSignal
subscription
> with Config|symbol limit set to 90.
>
> Saw no problem in scanning > 100 symbols with 'Wait for Backfill'
> checked;Data Manager|Data|Symbols in fact showed a max of 56
symbols.
>
> Data Manager, however, pops up the "Symbol limit exceeded ..." msg
when
> exiting AB and "saving symbols" is active.
>
> I'd appeciate it if anyone who has seen [or not seen] this or
similar
> problems would weigh in.
>
> TIA,
> Bob
------------------------ Yahoo! Groups Sponsor --------------------~-->
Yahoo! Domains - Claim yours for only $14.70
http://us.click.yahoo.com/Z1wmxD/DREIAA/yQLSAA/GHeqlB/TM
--------------------------------------------------------------------~->
Check AmiBroker web page at:
http://www.amibroker.com/
Check group FAQ at: http://groups.yahoo.com/group/amibroker/files/groupfaq.html
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/amibroker/
<*> To unsubscribe from this group, send an email to:
amibroker-unsubscribe@xxxxxxxxxxxxxxx
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|